1. From the end of a section, cut a 2-inch horizontal line at the top of the leg then cut vertically down cutting off the 2-inch piece of leg. Finally cut a 2-inch horizontal line where the nose begins to form and cut off that 2-inch piece of nose, cutout and clip. Bend the remaining piece of slope down toward the bottom of the gutter to form an end cap.

4. Insert the Vertical Leg inside and against the back wall of the K-Gutter.

NOTE: If the vertical leg is too high, simply cut the vertical leg horizontally where scored to fit your gutter.

5. VERY IMPORTANT The CLIP MUST SNAP-FIT ONTO THE LIP OF K-GUTTER AS SHOWN TO ALLOW RAINWATER TO ENTER THE GUTTER:

Squeeze the Nose toward the Back Wall until the Clip snap-fits onto the Lip as shown, to allow rainwater to enter the gutter.

NOTE: It is NOT necessary to snap-fit an entire Section between the Vertical Leg and the Lip all at once. It may be easier to squeeze one end of a Section until the Clip clasps onto the Lip and then to gradually snap-fit the Section onto the Lip, a little at a time.